R&S SMA100B - Page 480

Remote control commands
R&S
®
SMA100B
480User Manual 1178.3834.02 ─ 09
Example: See Example "Activating screen saver mode and display
update" on page 477
Manual operation: See "Display Update is" on page 345
:DISPlay:ANNotation:AMPLitude <State>
Indicates asterisks instead of the level values in the status bar.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 1)
Example: See Example "Activating screen saver mode and display
update" on page 477
Manual operation: See "Annotation Amplitude" on page 366
:DISPlay:ANNotation:FREQuency <State>
Indicates asterisks instead of the frequency values in the status bar.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 1)
Example: See Example "Activating screen saver mode and display
update" on page 477
Manual operation: See "Annotation Frequency" on page 366
:DISPlay:ANNotation[:ALL] <State>
Displays asterisks instead of the level and frequency values in the status bar of the
instrument.
We recommend that you use this mode if you operate the instrument in remote control.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 1
Example: See Example "Activating screen saver mode and display
update" on page 477
:DISPlay:DIALog:ID?
Returns the dialog identifiers of the open dialogs in a string separated by blanks.
Return values:
<DialogIdList> <DialogID#1>< ><DialogID#2>< > ... < ><DialogID#n>
DISPlay subsystem