R&S SMA100B - RF Level Settings

RF signal configuration
R&S
®
SMA100B
74User Manual 1178.3834.02 ─ 09
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 648
[:SOURce<hw>]:POWer:STEP[:INCRement] on page 688
4.6 RF level settings
Access:
1. Select "Level" > "RF Level".
In the "RF Level" dialog, you can configure the offset-free level, the level limit, and
the step width for varying the level with the rotary knob.
2. Select "User Variation" to set the step width to be used when .setting the RF level
using the rotary knob.
3. Observe the information on the home screen, "Level" tile.
RF level settings