R&S SMA100B - LF Sweep Settings

Remote control commands
R&S
®
SMA100B
661User Manual 1178.3834.02 ─ 09
Example: See Example "Configuring the LF generator" on page 653.
Manual operation: See "Trapezoid Rise / Fall" on page 117
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:PERiod <Period>
Sets the period of the generated pulse. The period determines the repetition frequency
of the internal signal.
Parameters:
<Period> float
Range: 1E-6 to 100
Increment: 10E-9
*RST: 0.001
Example: See Example "Configuring the LF generator" on page 653.
Manual operation: See "Period" on page 116
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:RISE
<Rise>
Selects the rise time for the triangle single of the LF generator.
Parameters:
<Rise> float
Range: 1E-6 to 100
Increment: 10E-9
*RST: 0.5E-3
Example: See Example "Configuring the LF generator" on page 653.
Manual operation: See "Triangle Rise" on page 117
14.16.6.2 LF sweep settings
With the commands described in this section, you can configure the sweep of the LF
signal.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl................................................... 661
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute................................................662
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE....................................................662
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:POINts...................................................663
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace............................................... 663
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?..............................................663
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe...................................................663
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing................................................ 664
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic..................................664
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]........................................ 664
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl <Dwell>
Sets the dwell time for each frequency step of the sweep.
SOURce subsystem