R&S SMA100B - Network Settings

Network operation and remote control
R&S
®
SMA100B
397User Manual 1178.3834.02 ─ 09
You find the remote control command sets supported by the R&S SMA100B in a selec-
tion list.
For more information, see the application note:
1GP120: Remote Emulation with the R&S SMA100B Signal Generator.
The selected instrument also defines the identification string that is retrieved with query
*IDN?. If necessary, use the parameter Mode and IDN String to change this string.
As any other parameter, the remote control command set can also be changed
remotely by the command :SYSTem:LANGuage.
While working in an emulation mode, the R&S SMA100B specific command set is dis-
abled and the SCPI command :SYSTem:LANGuage is discarded.
To return to the SCPI command set of the R&S SMA100B, use the appropriate com-
mand of the selected command set.
If for example an HP generator is emulated, the HP command EX returns to the instru-
ment-specific GPIB command set.
13.5.1 Network settings
Access:
► Select "System Config > Remote Access > Network".
In the "Network" dialog, you can configure the settings of the general network envi-
ronment and specific identification parameters of the instrument in the network.
Remote access settings