Network operation and remote control
R&S
®
SMA100B
398User Manual 1178.3834.02 ─ 09
The remote commands required to configure the network remotely are described in
Chapter 14.17, "SYSTem subsystem", on page 712.
How to: see Chapter 13.7.3, "How to connect to LAN", on page 415.
Network Status
Indicates that the instrument is connected to the network.
Remote command:
:SYSTem:COMMunicate:NETWork:STATus? on page 725
Restart Network
Terminates the network connection of the instrument and sets it up again. You can use
this function to fix network problems.
Note: This function restarts only the connection of the instrument to the network. It
does not impact the network itself.
Remote command:
:SYSTem:COMMunicate:NETWork:RESTart on page 724
Hostname
Displays the hostname.
Each instrument is delivered with an assigned hostname, a logical name which can be
used instead of the IP address. With the default network settings, the IP address is
allocated by the DHCP server. This address can change each time the instrument is
reconnected. Unlike the IP address, the hostname name does not change.
Note:
This function is password-protected. Unlock the protection level 1 to access it.
●
We recommend that you do not change the default network settings or the host-
name to avoid problems with the network connection.
If you change the hostname, be sure to use a unique name.
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname on page 725
Workgroup
Sets the individual windows workgroup name of the R&S SMA100B. This parameter is
required in case the instrument is integrated in a windows network.
This function is password-protected. Unlock the protection level 1 to access it.
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup on page 725
Address Mode
Selects the mode for assigning the IP address.
How to: Chapter 13.7.4, "How to assign the IP address", on page 416
"Auto (DCHP)"
Assigns the IP address automatically, provided the network supports
DHCP (Dynamic Host Configuration Protocol).
"Static"
Enables you to assign the IP address manually.
Remote access settings
To Next Page
Loading...
