R&S SMA100B - Source:phase Subsystem; Source:power Subsystem

Remote control commands
R&S
®
SMA100B
681User Manual 1178.3834.02 ─ 09
14.16.10 SOURce:PHASe subsystem
This subsystem contains the commands for adjusting the phase of the RF output signal
relative to a reference signal of the same frequency.
Example: Programming Example
// change the phase relative to the current phase
SOURce1:PHASe 2 DEG
// adopt the setting as the current phase
SOURce1:PHASe:REFerence
The following commands are available:
[:SOURce<hw>]:PHASe................................................................................................. 681
[:SOURce<hw>]:PHASe:REFerence................................................................................681
[:SOURce<hw>]:PHASe <Phase>
Sets the phase variation relative to the current phase.
Parameters:
<Phase> float
Range: -36000 to 36000
Increment: 0.001
*RST: 0
Default unit: DEG
Example: See Example "Programming Example" on page 681.
Manual operation: See "Delta Phase" on page 80
[:SOURce<hw>]:PHASe:REFerence
Assigns the value set with command [:SOURce<hw>]:PHASe as the reference
phase.
Example:
See Example "Programming Example" on page 681.
Usage: Event
Manual operation: See "Reset Delta Phase Display" on page 80
14.16.11 SOURce:POWer subsystem
The SOURce:POWer subsystem contains the commands for setting the output level,
level control and level correction of the RF signal.
The default units are dBm. To change the units, perform one of the following:
●
Enter the unit after the numerical value
Example: :POW 0.5V
●
Set the unit with the command :UNIT:POWer.
SOURce subsystem