R&S SMA100B - Page 80

RF signal configuration
R&S
®
SMA100B
80User Manual 1178.3834.02 ─ 09
Frequency Range
Selects the mode that determines the frequency range for the phase continuity of the
RF signal.
The available frequency range depends on the selected mode and is limited by the res-
olution of the used synthesizer. It varies depending on the frequency, and is set when
you activate the phase continuous settings.
"Narrow"
Sets a small frequency range, asymmetrically around the RF fre-
quency.
"Wide"
Option: R&S SMAB-B711
Sets a large frequency range, symmetrically around the RF fre-
quency.
Remote command:
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:MODE on page 650
Frequency Range From / To
Displays the frequency range for phase continuous settings.
The value range depends on the mode selected with Frequency Range.
Remote command:
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:LOW? on page 649
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:HIGH? on page 649
Delta Phase
Sets the phase of the RF signal.
The current phase of the signal is used as the reference.
Remote command:
[:SOURce<hw>]:PHASe on page 681
Reset Delta Phase Display
Adopts the selected "Delta Phase" value as the current value, and resets delta phase
to 0 degrees.
Remote command:
[:SOURce<hw>]:PHASe:REFerence on page 681
RF phase settings