R&S SMA100B - Page 79

RF signal configuration
R&S
®
SMA100B
79User Manual 1178.3834.02 ─ 09
In the "Phase" tab, you can activate the phase continuous mode, set the delta
phase parameter and reset the phase to this reference.
2. Switch to the home screen, "Frequency" tile.
The R&S SMA100B indicates the configured settings.
The remote commands required to define the settings are described in Chap-
ter 14.16.10, "SOURce:PHASe subsystem", on page 681.
Settings
Phase Continuous Active..............................................................................................79
Frequency Range..........................................................................................................80
Frequency Range From / To......................................................................................... 80
Delta Phase...................................................................................................................80
Reset Delta Phase Display........................................................................................... 80
Phase Continuous Active
Activates generation of a phase continuous frequency signal.
The R&S SMA100B generates a phase continuous output sinewave, i.e. without phase
discontinuity or glitch when changing the frequency.
For a given RF frequency, the frequency range is limited.
Remote command:
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:STATe on page 650
RF phase settings