R&S SMA100B - Configure Sensors Settings

Improving level performance
R&S
®
SMA100B
259User Manual 1178.3834.02 ─ 09
The measurement is started in the diagram using the "Start" button. During measure-
ment, the "Start" button is replaced by a "Stop" button which can be used to abort the
measurement. The progress bar indicates the status of the measurement.
"Single"
Selects single measurement.
"Cont."
Selects continuous measurements.
Remote command:
:SENSe[:POWer]:SWEep:RMODe on page 529
:SENSe[:POWer]:SWEep:POWer:RMODe on page 526
:SENSe[:POWer]:SWEep:FREQuency:RMODe on page 513
:SENSe[:POWer]:SWEep:TIME:RMODe on page 531
All Trigger Events - Power Analysis
Selects the trigger mode for measurements in the time domain.
The measurement data processing starts with a trigger event in one of the sensors
(Logical OR), or when all channels are triggered (logical AND). Each sensor evaluates
a trigger event according to its setting independently.
This function supports the internal or external trigger modes with multi-channel time
measurements.
"Wired AND"
The measurement starts when all channels are triggered.
"Wired OR"
The measurement starts when a trigger event occurs.
Remote command:
:SENSe[:POWer]:SWEep:TIME:TEVents on page 532
Configure sensors settings
Access:
1. Select "Clk Syn/Power Sens" > "NRP-Z Power Analysis".
2. Select "Configure" > "Configure Sensors"
Using power sensors