R&S SMA100B - Page 532

Remote control commands
R&S
®
SMA100B
532User Manual 1178.3834.02 ─ 09
Parameters:
<Steps> integer
Range: 10 to 1000
*RST: 500
Example:
SENS:SWE:TIME:STEP 500
Sets the 500 measurement steps.
Manual operation: See "Steps - Power Analysis" on page 257
:SENSe[:POWer]:SWEep:TIME:STOP
<Stop>
Sets the stop time for the power versus time measurement.
Parameters:
<Stop> float
Range: 0 to 2
Increment: 1E-12
*RST: 1E-3
Example:
SENS:SWE:TIME:STOP 1ms
Sets the stop time to 1 ms.
Manual operation: See "Max - Power Analysis" on page 257
:SENSe[:POWer]:SWEep:TIME:TEVents <TriggerTEvents>
Determines, whether the measurement data processing starts with a trigger event in
one of the sensors (Logical OR), or whether all channels have to be triggered (logical
AND). Each sensor evaluates a trigger event according to its setting independently.
This function supports the internal or external trigger modes with multi-channel time
measurements.
Parameters:
<TriggerTEvents> AND | OR
*RST: AND
Example:
SENS:POW:SWE:TIME:TEV AND
The measurement data processing starts when all channels are
triggered.
Options: Option R&S SMAB-K28
Manual operation: See "All Trigger Events - Power Analysis" on page 259
:SENSe[:POWer]:SWEep:TIME:YSCale:AUTO <Auto>
Activates autoscaling of the Y axis in the diagram.
Parameters:
<Auto> OFF | CEXPanding | FEXPanding | CFLoating | FFLoating
Power sensor measurement subsystems