R&S SMA100B - Page 531

Remote control commands
R&S
®
SMA100B
531User Manual 1178.3834.02 ─ 09
:SENSe[:POWer]:SWEep:TIME:RMODe <RMode>
Selects single or continuous mode for measurement mode time in power analysis.
Parameters:
<RMode> SINGle | CONTinuous
*RST: CONTinuous
Example:
SENS:SWE:TIME:RMOD SING
Selects single measurement.
Manual operation: See "Execution - Power Analysis" on page 258
:SENSe[:POWer]:SWEep:TIME:SPACing[:MODE] <Mode>
Queries the sweep spacing for the power versus time measurement. The spacing is
fixed to linear.
Parameters:
<Mode> LINear
*RST: LINear
Example:
SENS:SWE:TIME:SPAC?
Queries the sweep spacing.
Manual operation: See "Spacing - Power Analysis" on page 258
:SENSe[:POWer]:SWEep:TIME:STARt <Start>
Sets the start time for the power versus time measurement. Value 0 defines the trigger
point. By choosing a negative time value, the trace can be shifted in the diagram. It is
possible, that the measurement cannot be performed over the complete time range
because of limitations due to sensor settings. In this case, an error message is output.
Parameters:
<Start> float
Range: -1 to 1
Increment: 1E-12
*RST: -5E-6
Example:
SENS:SWE:TIME:STAR 0s
Sets the start time to 0 s.
Manual operation: See "Min - Power Analysis" on page 256
:SENSe[:POWer]:SWEep:TIME:STEPs <Steps>
Sets the number of measurement steps for the power versus time measurement. Value
0 defines the trigger point.
Power sensor measurement subsystems