Remote control commands
R&S
®
SMA100B
449User Manual 1178.3834.02 ─ 09
14 Remote control commands
In the following, all remote-control commands are presented in detail with their param-
eters and the ranges of numerical values.
For an introduction to remote control and the status registers, see Chapter 13, "Net-
work operation and remote control", on page 378.
14.1 Conventions used in SCPI command descriptions
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Parameters that are only returned as the result of a query are indicated as Return
values.
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed. All commands used by the R&S SMA100B follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an Asynchronous
command.
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (*RST
command) are indicated as *RST values, if available.
●
Factory preset values
Default parameter values that are reset only by factory preset.
●
Default unit
The default unit is used for numeric values if no other unit is provided with the
parameter.
●
Manual operation
If the result of a remote command can also be achieved in manual operation, a link
to the description is inserted.
Conventions used in SCPI command descriptions
To Next Page
Loading...
