R&S SMA100B - Activating Analog Modulations; Modulation Settings; Pulse Modulation Settings

Analog modulations
R&S
®
SMA100B
84User Manual 1178.3834.02 ─ 09
– excludes PhiM, avionics and pulse modulation
– disables automatic level control (ALC)
– can not be operated with an external modulation signal
For more information, see data sheet.
5.3 Activating analog modulations
► Use one of the following:
● Select "Modulation > Amplitude Modulation/Frequency Modulation/Phase Mod-
ulation > State > ON".
● Select "Modulation > MOD ON".
● Press the [Mod on/off] key.
[Mod on/off]
Activate one or more analog modulations and press the [Mod on/off] key to toggle the
state of them all.
Pressing the key again restores the status that was active before the last switch-off.
Remote command:
[:SOURce<hw>]:MODulation[:ALL][:STATe] on page 561
5.4 Modulation settings
Access:
► Select "Modulation" > "Modulation Sources".
The "Modulation" dialog contains all functions and settings to configure the analog
modulations, the LF signal sources for performing a modulation, and the LF signal
output.
The remote commands required to define these settings are described in:
● Chapter 14.16.1.2, "SOURce:AM subsystem", on page 562
● Chapter 14.16.1.4, "SOURce:FM subsystem", on page 572
● Chapter 14.16.1.5, "SOURce:PM subsystem", on page 577
● Chapter 14.16.1.6, "SOURce:PULM subsystem", on page 581
● Chapter 14.16.1.3, "SOURce:CHIRp subsystem", on page 568
● Chapter 14.16.6, "SOURce:LFOutput subsystem", on page 652
5.4.1 Pulse modulation settings
Option: see Chapter 5.1, "Required options", on page 81.
Modulation settings