R&S SMA100B - Page 85

Analog modulations
R&S
®
SMA100B
85User Manual 1178.3834.02 ─ 09
Access:
► Select "Modulation" > "Pulse Modulation".
The "Pulse Modulation" dialog contains all parameters required to configure the
pulse modulator and the pulse generator.
It also displays the pulse signal graphically.
For an overview of the supported signals sources and related connectors, see Chap-
ter 5.2, "Modulation types and signal sources", on page 81.
The remote commands required to define these settings are described in Chap-
ter 14.16.1.6, "SOURce:PULM subsystem", on page 581.
Settings:
State..............................................................................................................................85
Source...........................................................................................................................85
Transition Type..............................................................................................................86
State
Activates pulse modulation and triggers the following automatic settings:
●
Pulse generator is activated.
The signal is output at the Pulse Video connector.
To deactivate the signal output, set "Pulse Generator" > Pulse Output State > "Off".
Remote command:
[:SOURce<hw>]:PULM:STATe on page 585
Source
Selects between the internal "Pulse Generator" or an "External" pulse signal for the
modulation.
"Pulse Generator"
Selects the internal generator.
See Pulse generator.
"External"
Modulation source is fed to the input connector.
See "Signal sources" on page 81.
Modulation settings