Troubleshooting and notifications
R&S
®
SMA100B
747User Manual 1178.3834.02 ─ 09
The message is displayed until the error is eliminated. It covers the status display in
the info line. After error elimination, the message automatically disappears and is also
recorded in the history.
Remote command:
:SYSTem:ERRor:STATic?
15.2 SCPI notifications
The SCPI notifications are similar for all SCPI instruments. Detailed information and an
overview of all notifications as defined in SCPI standard can be found in the corre-
sponding documentation.
SCPI notifications have negative codes (numbers). The error text being entered into
the error/event queue or being displayed is printed in bold face on the left together with
the error code. Below the error text, there is an explanation to the respective error.
15.3 Device-specific notifications
Start-up error
If device-specific notifications occur during operation, the R&S SMA100B issues corre-
sponding error messages, as listed under Errors during operation. However, problems
can also occur during start-up.
If your instrument prompts this notification when starting up, some information during
initialization is missing. This error can occur when the power supply was interrupted
during the last boot-up, e.g. due to power failure.
Remedy
► Select "Reset this error".
● If the operating system and the firmware boot successfully, the functionality is
restored.
● If the notification reappears, a hardware error has occurred.
We recommend that you contact the Rohde & Schwarz customer support
(https://www.rohde-schwarz.com/support), or ship your R&S SMA100B directly
to the service center experts for troubleshooting (http://www.services.rohdesch-
warz.com).
Device-specific notifications
To Next Page
Loading...
