R&S SMA100B - Diagnostic Subsystem

Remote control commands
R&S
®
SMA100B
474User Manual 1178.3834.02 ─ 09
:CSYNthesis:FREQuency:STEP <Step>
Sets the step width of the rotary knob and, in user-defined step mode, increases or
decreases the frequency.
Parameters:
<Step> float
Range: 0 to 14999E5
Increment: 0.001
*RST: 1E6
Example: See Chapter 14.7, "CSYNthesis subsystem", on page 469.
Manual operation: See "Variation Step" on page 307
14.8 DIAGnostic subsystem
The DIAGnostic subsystem contains the commands used for instrument diagnosis
and servicing. SCPI does not define any DIAGnostic commands; the commands lis-
ted here are all device-specific. All DIAGnostic commands are query commands
which are not affected by *RST.
The test functions are intended for services purposes.
They are thus password-protected functions. Unlock the corresponding protection level
to access them, see :SYSTem:PROTect<ch>[:STATe]
For more information, see R&S SMA100B Service Manual.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
DIAGnostic<hw>
[1] Optional suffix
DIAGnostic subsystem