R&S SMA100B - Page 307

Clock synthesis
R&S
®
SMA100B
307User Manual 1178.3834.02 ─ 09
Remote command:
:CSYNthesis:OFFSet:STATe on page 472
DC Offset
Sets the value of the DC offset for both clock synthesis signal outputs.
Remote command:
:CSYNthesis:OFFSet on page 472
Voltage
For Output Type = "CMOS", sets the high-level of the output signal.
Remote command:
:CSYNthesis:VOLTage on page 472
Delta Phase
Shifts the phase of the generated clock signal.
Remote command:
:CSYNthesis:PHASe on page 472
Reset Delta Phase Display
Resets the parameter Delta Phase.
User Variation
Defines and activates a user-defined step width for varying the frequency or level with
the rotary knob.
If disabled, the step width varies in steps of one unit at the cursor position.
Variation Active ← User Variation
Activates the set user-defined step width.
Remote command:
:CSYNthesis:FREQuency:STEP:MODE on page 473
:CSYNthesis:POWer:STEP:MODE on page 473
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
:CSYNthesis:FREQuency:STEP on page 474
:CSYNthesis:POWer:STEP[:INCRement] on page 473