R&S SMA100B - Accessing Files with User Data; File Select Settings

File and data management
R&S
®
SMA100B
321User Manual 1178.3834.02 ─ 09
5. Select "Recall Immediate 1"
The instrument is restored to the previous state.
6. Select "Recall Immediate 2" to switch to the settings saved in the second file.
To save complete instrument settings
1. Select "System Config > Save/Recall" > "Operation Mode > Save".
2. In the file selection dialog, select a filename and storage location for the settings
file.
3. Select "Save".
A file with the defined name and path and the extension *.savrcltxt is created.
To restore instrument's configuration
Save the configuration as described in "To save complete instrument settings"
on page 321.
1. To restore settings, select "System Config > Save/Recall" > "Operation Mode >
Recall".
2. To retain the current frequency and level settings, enable "Save/Recall > Exclude
Frequency/Level"
3. In the file selection dialog, select the filename and storage location of the settings
file.
The settings are restored, but the frequency and level settings are retained; you
can repeat the signal generation with the same settings.
See also Chapter 11.2.3, "How to recall user settings automatically after preset",
on page 315.
11.5 Accessing files with user data
Signal generation in list mode, the generation of pulse train signals or applying user
correction values use data from list files. Whenever a list file is required as a data
source, the instrument provides direct access to the standard "File Select" function.
This function enables you to select, create and edit the list files.
11.5.1 File select settings
The "File Select" dialog opens automatically each time the signal generation requires
list file as data source.
To access a loadable data list file
1. Select "Sweep" > "List Mode Data" > "List Mode" = "Data".
A file select dialog for loading, creating and modifying a file opens.
Accessing files with user data