R&S SMA100B - How to Transfer Files from and to the Instrument

File and data management
R&S
®
SMA100B
330User Manual 1178.3834.02 ─ 09
If the connection does not succeed, consider to check the following:
●
Is the network folder or computer you try to map turned on?
●
Is the network folder or computer enabled for remote access?
●
Does the selected user name have the necessary permissions?
See also Chapter 11.9.5, "Using a file server for test files exchange", on page 335.
11.9 How to transfer files from and to the instrument
As explained in "File handling" on page 310, you access the file system of the
R&S SMA100B via one of the following ways:
●
Via the built-in "File Manager"
See Chapter 11.8, "Using the file manager", on page 324.
●
On an instrument connected to a LAN:
– Via one of the standard functions FTP or SMB (samba)
See Chapter 11.9.2, "Accessing the file system of the R&S SMA100B via FTP",
on page 332 and
Chapter 11.9.3, "Accessing the R&S SMA100B file system via SMB (Samba)",
on page 333
– Via mapped network drives
See Chapter 11.8.4, "How to map a network folder", on page 328.
●
Via a connected USB storage device
See Chapter 11.9.4, "Using a USB storage device for file transfer", on page 335
Mainly because of security reasons, the access to the file system of your
R&S SMA100B can be denied, because one or all these access methods are deliber-
ately disabled. Access to the file system via LAN and/or USB requires that the corre-
sponding service is enabled and a write access to the file system is enabled. Refer to
How to transfer files from and to the instrument