R&S SMA100B - General Settings

List and sweep mode
R&S
®
SMA100B
202User Manual 1178.3834.02 ─ 09
7.6.1 General settings
Access:
► Select "Sweep" > "List mode".
In the "General" tab, you can configure the trigger and dwell time modes for list
processing and activate signal generation.
Settings
State............................................................................................................................202
Current Index.............................................................................................................. 202
Mode........................................................................................................................... 203
Dwell Time Mode.........................................................................................................203
Global Dwell Time....................................................................................................... 203
Trigger Slope...............................................................................................................203
Reset...........................................................................................................................204
Execute Single............................................................................................................ 204
State
Activates the list mode and processes the currently selected list.
Note: Active RF frequency, RF level or RF combined sweep modes deactivate the LF
sweep or List mode and vice versa.
Remote command:
[:SOURce<hw>]:FREQuency:MODE on page 643
Current Index
Sets the list index for list processing in "Step" mode. In the other modes, the index indi-
cates the current step.
Remote command:
[:SOURce<hw>]:LIST:INDex on page 670
List mode settings