R&S SMA100B - Setting up the R&S SMA100 B; Placing the R&S SMA100 B on a Bench Top

Getting started
R&S
®
SMA100B
27User Manual 1178.3834.02 ─ 09
– Environments that are directly connected to a low-voltage supply network that
supplies residential buildings
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
If class A equipment causes radio disturbances, take appropriate measures to
eliminate them.
3.1.4 Setting up the R&S SMA100B
See also:
●
"Setting up the product" on page 20
●
"Intended use" on page 19
3.1.4.1 Placing the R&S SMA100B on a bench top
To place the product on a bench top
1. Place the product on a stable, flat and level surface. Ensure that the surface can
support the weight of the product. For information on the weight, see the data
sheet.
2.
CAUTION! Foldable feet can collapse. See "Setting up the product" on page 20.
Always fold the feet completely in or out. With folded-out feet, do not place any-
thing on top or underneath the product.
3.
WARNING! A stack of products can fall over and cause injury. Never stack more
than three products on top of each other. Instead, mount them in a rack.
Stack as follows:
● If the products have foldable feet, fold them in completely.
● It is best if all products have the same dimensions (width and length). If the
products have different dimensions, stack according to size and place the
smallest product on top.
● Do not exceed the permissible total load placed on the product at the bottom of
the stack:
– 50 kg when stacking products of identical dimensions (left figure).
– 25 kg when stacking smaller products on top (middle figure).
Preparing for use