R&S SMA100B - Shape

List and sweep mode
R&S
®
SMA100B
191User Manual 1178.3834.02 ─ 09
Shape
Selects the waveform shape of the sweep signal.
"Sawtooth"
The sweep runs from start to stop frequency. The subsequent sweep
starts at the start value, i.e. the shape of the sweep sequence resem-
bles a sawtooth.
Figure 7-11: Sweep signal sawtooth shape
1 = Start value
2 = Stop value
3 = Step width
"Triangle"
The sweep runs from start to stop value and back, i.e. the shape of
the sweep resembles a triangle. Each subsequent sweep starts at the
start frequency.
The triangle shape is only available for Sweep Type > Step.
Figure 7-12: Sweep signal triangle shape
1 = Start value
2 = Stop value
3 = Step width
Remote command:
RF frequency sweep:
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe on page 705
RF level sweep:
Sweep mode settings