To Next Page

To Previous Page

List and sweep mode

R&S

SMA100B

201User Manual 1178.3834.02 ─ 09

Marker Polarity

Sets the polarity of the marker signal.

The duration of the active signal is equal to the dwell time of a step.

Remote command:

[:SOURce<hw>]:SWEep:MARKer:OUTPut:POLarity on page 710

Active Marker

Boosts a specific marker signal so that it is output with higher voltage than all other

markers.

Remote command:

[:SOURce<hw>]:SWEep[:FREQuency]:MARKer:ACTive on page 711

7.6 List mode settings

The "List Mode" dialog contains all the functions and settings for creating and handling

lists with RF frequency/level pairs including the corresponding dwell times for generat-

ing the RF signal based on these values.

Access:

► Select "Sweep" > "List mode".

The dialog contains parameters for configuring the list mode processing, entering

list mode data and transferring data files from or to the instrument.

The remote commands required to define these settings are described in Chap-

ter 14.16.7, "SOURce:LIST subsystem", on page 665.

● General settings....................................................................................................202

● List mode data settings......................................................................................... 204

● Import/export settings............................................................................................205

List mode settings

R&S SMA100B User Manual

Other manuals for R&S SMA100B