R&S SMA100B - Page 710

Remote control commands
R&S
®
SMA100B
710User Manual 1178.3834.02 ─ 09
[:SOURce<hw>]:SWEep:COMBined:SHAPe <Shape>
Selects the waveform shape for the combined frequency / level sweep sequence.
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example "Setup an RF frequency or power sweep"
on page 697.
Manual operation: See "Shape" on page 191
[:SOURce<hw>]:SWEep:RESet[:ALL]
Resets all active sweeps to the starting point.
Usage:
Event
Manual operation: See "Reset Sweep" on page 193
[:SOURce<hw>]:SWEep[:FREQuency]:TIME <Time>
Sets the duration of a frequency ramp sweep step.
Parameters:
<Time> float
Range: 0.01 to 100
Increment: 1E-4
*RST: 0.015
Default unit: s
Example:
SOURce1:SWEep:FREQuency:SPACing RAMP
SOURce1:SWEep:FREQuency:TIME 0.020
Options: R&S SMAB-B28
Manual operation: See "Sweep Time" on page 192
[:SOURce<hw>]:SWEep:MARKer:OUTPut:POLarity <Polarity>
Selects the polarity of the marker signal.
Parameters:
<Polarity> NORMal | INVerted
NORMal
Marker level is high when after reaching the mark.
INVerted
Marker level is low after reaching the mark.
*RST: NORMal
Example: See [:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:
FREQuency on page 711.
SOURce subsystem