R&S SMA100B - Output Subsystem

Remote control commands
R&S
®
SMA100B
489User Manual 1178.3834.02 ─ 09
:KBOard:LAYout <Layout>
Selects the language for an external keyboard and assigns the keys acccordingly.
Parameters:
<Layout> CHINese | DANish | DUTCh | DUTBe | ENGLish | ENGUK |
FINNish | FRENch | FREBe | FRECa | GERMan | ITALian |
JAPanese | KORean | NORWegian | PORTuguese | RUSSian |
SPANish | SWEDish | ENGUS
*RST: n.a. (factory preset: ENGLish)
Example:
:KBOard:LAYout US
// activates American keyboard
Manual operation: See "USB Keyboard > Layout" on page 344
14.13
OUTPut subsystem
In the OUTPut subsystem, you can configure the output signals.
The LF output signal is defined with the commands of the Chapter 14.16.6,
"SOURce:LFOutput subsystem", on page 652 system.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
OUTPut<hw>
[1] Optional suffix
:OUTPut:ALL[:STATe]..................................................................................................... 489
:OUTPut<hw>[:STATe]....................................................................................................490
:OUTPut<hw>[:STATe]:PON............................................................................................490
:OUTPut<hw>:AMODe................................................................................................... 490
:OUTPut<hw>:FILTer:MODE........................................................................................... 491
:OUTPut<hw>:IMPedance?.............................................................................................491
:OUTPut:FPRoportional:SCALe.......................................................................................491
:OUTPut:USER:MARKer.................................................................................................492
:OUTPut<hw>:AFIXed:RANGe:LOWer?...........................................................................492
:OUTPut<hw>:AFIXed:RANGe:UPPer?............................................................................492
:OUTPut<hw>:PROTection:CLEar................................................................................... 492
:OUTPut<hw>:PROTection:TRIPped?.............................................................................. 493
:OUTPut:ALL[:STATe] <State>
Activates the RF output signal of the instrument.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 0)
OUTPut subsystem