R&S SMA100B - Fill with Sensor

Improving level performance
R&S
®
SMA100B
229User Manual 1178.3834.02 ─ 09
8.3.3 Fill with sensor
Access:
1. Select "Level" > "User Correction".
2. Select "UCOR Data > navigate to the file *.ucor > Select".
3. Select "Edit UCOR Data > Fill With Sensor...".
This dialog contains parameters for filling a table automatically with sensor read-
ings.
To fill the table, select "Execute".
For information on power sensors an how to use them, see Chapter 8.5, "How to cali-
brate the power level with an R&S NRP power sensor", on page 290.
Settings
Fill User Correction Data with Sensor......................................................................... 229
Used SMAB Settings For Measurement..................................................................... 230
Fill User Correction Data with Sensor
●
"Sensor"
Displays connected sensors for selection.
●
"List To Fill"
Indicates the used list.
●
"S-Parameter"
Indicates whether S-Parameter correction in the R&S NRP power sensor is used.
●
"Include Zeroing"
User correction