Troubleshooting and notifications
R&S
®
SMA100B
752User Manual 1178.3834.02 ─ 09
15.6 Measuring USB cable quality
To check the quality of the USB cable, see the service manual of the R&S SMA100B.
15.7 Requesting instrument configuration and specifica-
tions
The R&S SMA100B is equipped with various hardware and software components. To
get an overview of what your instrument is equipped with, you can request the assem-
blies, hardware and software options, and the firmware version. The components are
structured according to the hardware configuration, software options, including the
license management, and externally used Rohde & Schwarz equipment, like R&S NRP
power sensors.
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option. How to install options is described in
chapter 4 of the R&S SMA100B service manual.
The installation of hardware options purchased at a later stage is also described in
chapter 4 of the service manual. Most of the hardware options have to be installed at
an authorized Rohde & Schwarz service center.
15.7.1 Hardware configuration settings
Access:
► Select "System Config > Setup > Instrument Assembly > Hardware Config".
Requesting instrument configuration and specifications
To Next Page
Loading...
