R&S SMA100B - How to Enable the VNC Service; Operating the R&S SMA100 B Remotely Using VNC

Network operation and remote control
R&S
®
SMA100B
439User Manual 1178.3834.02 ─ 09
● On the front panel, press the [Help] key.
The help topic opens. Apart from the function description, it contains the SCPI
command in detailed syntax.
How to find the corresponding GUI function to a command
Conversely, if you are looking for a function in the GUI, which belongs to a SCPI, you
find it via a cross-reference in the online help and in the user manual.
13.10 Operating the R&S SMA100B remotely using VNC
This section shows you some examples of the various possibilities to set up remote
operation.
●
Using a desktop system
– Chapter 13.10.2.1, "Using a web browser", on page 440
– Chapter 13.10.2.2, "Using a VNC client software", on page 440
●
Using a smart device
– Chapter 13.10.3.1, "Using a VNC app", on page 443
– Chapter 13.10.3.2, "Using a web browser with HTML5", on page 443
– Chapter 13.10.3.3, "Special mode QR code", on page 444
13.10.1 How to enable the VNC service
1.
NOTICE! Enabled VNC service can lead to unauthorized access.
Change the computer name and password of the instrument.
See Chapter 12.4.5, "How to prevent unauthorized access", on page 373.
2. Select "System Config > Setup > Security > Security > LAN Services".
3. Select "VNC > On".
4. Enter the Security Password.
5. Select "Accept".
Operating the R&S
SMA100B remotely using VNC