R&S SMA100B - Page 472

Remote control commands
R&S
®
SMA100B
472User Manual 1178.3834.02 ─ 09
*RST: -20
Example: See Chapter 14.7, "CSYNthesis subsystem", on page 469.
Manual operation: See "Level" on page 306
:CSYNthesis:OFFSet:STATe <State>
Activates a DC offset.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Chapter 14.7, "CSYNthesis subsystem", on page 469.
Manual operation: See " DC Offset State" on page 306
:CSYNthesis:OFFSet
<Offset>
Sets the value of the DC offset.
Parameters:
<Offset> float
Range: -5 to 5
Increment: 0.001
*RST: 0
Example: See Chapter 14.7, "CSYNthesis subsystem", on page 469.
Manual operation: See "DC Offset" on page 307
:CSYNthesis:VOLTage <Voltage>
Sets the voltage for the CMOS signal.
Parameters:
<Voltage> float
Range: 0.8 to 2.7
Increment: 0.001
*RST: 1.8
Example:
CSYNthesis:OTYPe CMOS
CSYNthesis:VOLTage 1.8
CSYNthesis:FREQuency 100000000
CSYNthesis:STATe 1
Manual operation: See "Voltage" on page 307
:CSYNthesis:PHASe <Phase>
Shifts the phase of the generated clock signal.
CSYNthesis subsystem