R&S SMA100B - Page 513

Remote control commands
R&S
®
SMA100B
513User Manual 1178.3834.02 ─ 09
:SENSe[:POWer]:SWEep:FREQuency:REFerence:DATA:XVALues <XValues>
Sets the x values of the two reference points, i.e. "Frequency X (Point A)" and "Fre-
quency X (Point B)" in "Frequency" measurement.
Parameters:
<XValues> string
Example:
SENSe:POW:SWE:FREQ:REF:DATA:XVAL 100MHZ,22GHZ
Sets the x value of reference "Point A" to 10 MHz, and the value
of "Point B" to 10 GHz.
Manual operation: See "Freq (X)" on page 253
:SENSe[:POWer]:SWEep:FREQuency:REFerence:DATA:YVALues
<YValues>
Sets or queries the y values of the two reference points, i.e."Pow Y (Point A)" and
"Power Y (Point B)" in "Frequency" measurement.
Parameters:
<YValues> string
Example:
SENSe:POW:SWE:FREQ:REF:DATA:YVAL -10,25
Sets the y value of reference "Point A" to -10 dBm, and the
value of "Point B" to -25 dBm.
Manual operation: See "POW (Y)" on page 253
:SENSe[:POWer]:SWEep:FREQuency:RMODe <RMode>
Selects single or continuous mode for measurement mode frequency in power analy-
sis.
Parameters:
<RMode> SINGle | CONTinuous
*RST: CONTinuous
Example:
SENS:SWE:FREQ:RMOD SING
Selects single measurement
Manual operation: See "Execution - Power Analysis" on page 258
:SENSe[:POWer]:SWEep:FREQuency:SPACing[:MODE] <Mode>
Selects the spacing for the frequency power analysis.
Parameters:
<Mode> LINear | LOGarithmic
*RST: LINear
Example:
SENS:SWE:FREQ:SPAC:MODE LIN
Sets linear spacing of the sweep
Manual operation: See "Spacing - Power Analysis" on page 258
Power sensor measurement subsystems