R&S SMA100B - Page 725

Remote control commands
R&S
®
SMA100B
725User Manual 1178.3834.02 ─ 09
:SYSTem:COMMunicate:NETWork:STATus?
Queries the network configuration state.
Return values:
<State> 1 | ON | 0 | OFF
Example: See Example "Retrieving information on network-related set-
tings" on page 713.
Usage: Query only
Manual operation: See "Network Status" on page 398
:SYSTem:COMMunicate:NETWork[:COMMon]:DOMain
<Domain>
Determines the primary suffix of the network domain.
Parameters:
<Domain> string
Example: See Example "Retrieving information on network-related set-
tings" on page 713.
Manual operation: See "DNS Suffix" on page 399
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname <Hostname>
Sets an individual hostname for the Signal Generator.
Note: We recommend that you do not change the hostname to avoid problems with
the network connection. If you change the hostname, be sure to use a unique name.
This is a password-protected function. Unlock the protection level 1 to access it.
Parameters:
<Hostname> string
Example: See Example "Retrieving information on network-related set-
tings" on page 713.
Manual operation: See "Hostname" on page 398
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup <Workgroup>
Sets an individual workgroup name for the instrument.
Parameters:
<Workgroup> string
Example: See Example "Retrieving information on network-related set-
tings" on page 713.
Manual operation: See "Workgroup" on page 398
SYSTem subsystem