R&S SMA100B - Page 729

Remote control commands
R&S
®
SMA100B
729User Manual 1178.3834.02 ─ 09
:SYSTem:IDENtification:PRESet
Sets the *IDN and *OPT strings in user defined mode to default values.
Example:
SYST:IDEN USER
SYST:IDEN:PRES
Usage: Event
Manual operation: See "Set to Default" on page 404
:SYSTem:IRESponse
<IdnResponse>
Defines the user defined identification string for *IDN.
Note: While working in an emulation mode, the instrument's specific command set is
disabled, i.e. the SCPI command SYST:IRES is discarded.
Parameters:
<IdnResponse> string
Example:
SYST:IDEN USER
// Selects a user-defined identification
SYST:IRES "Test Device"
// Defines identification string 'test device'
*IDN?
// Response: 'test device'
Manual operation: See "IDN String" on page 404
:SYSTem:ORESponse <OResponse>
Defines the user defined response string for *OPT.
Note: While working in an emulation mode, the instrument's specific command set is
disabled, i.e. the SCPI command SYST:ORES is discarded.
Parameters:
<OResponse> string
Example:
SYST:IDEN USER
// Selects a user-defined identification
SYST:ORES "Test Option"
// Defines the OPT string 'test option'
*OPT?
// Response: 'test option'
Manual operation: See "OPT String" on page 404
:SYSTem:LANGuage <Language>
Sets the remote control command set.
SYSTem subsystem