R&S SMA100B - Page 479

Remote control commands
R&S
®
SMA100B
479User Manual 1178.3834.02 ─ 09
:DISPlay:PSAVe[:STATe] <State>
Activates the screen saver mode of the display.
We recommend that you use this mode to protect the display, if you operate the instru-
ment in remote control.
To define the wait time, use the command :DISPlay:PSAVe:HOLDoff.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 0)
Example: See Example "Activating screen saver mode and display
update" on page 477
Manual operation: See "Screen Saver" on page 344
:DISPlay:BRIGhtness
<BRIGhtness>
Sets the brightness of the dispaly.
Parameters:
<BRIGhtness> float
Range: 1.0 to 20.0
Increment: 1.0
*RST: 14.0
Example:
DISPlay:BRIGhtness 14
Manual operation: See "Display" on page 344
:DISPlay:BUTTon:BRIGhtness <ButtonBrightnes>
Sets the brightness of the [RF on/off] key.
Parameters:
<ButtonBrightnes> integer
Range: 1 to 20
*RST: n.a. (no preset. default: 14)
Example:
DISPlay:BUTTon:BRIGhtness 15
Manual operation: See "RF Hardkey" on page 344
:DISPlay:UPDate[:STATe] <Update>
Activates the refresh mode of the display.
Parameters:
<Update> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 1)
DISPlay subsystem