R&S SMA100B - Page 262

Improving level performance
R&S
®
SMA100B
262User Manual 1178.3834.02 ─ 09
Activates the use of a different frequency other than the set signal generator fre-
quency for the measurement. The separate frequency value is set in the entry win-
dow below.
Remote command:
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:SRANge[:STATe]
on page 505
:SENSe<ch>[:POWer]:SWEep:POWer[:SENSor]:SFRequency:STATe
on page 507
:SENSe<ch>[:POWer]:SWEep:POWer[:SENSor]:SFRequency on page 506
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:SFRequency:STATe
on page 510
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:SFRequency on page 509
Min Frequency - Power Analysis
This parameter is only available for Configure measurement settings > "Frequency"
and Use Separate Frequency- Power Analysis > "Active".
Sets the minimum frequency of the measurement.
Remote command:
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:SRANge:STARt
on page 504
Max Frequency - Power Analysis
This parameter is only available for Configure measurement settings > "Frequency"
and Use Separate Frequency- Power Analysis > "Active".
Sets the maximum frequency of the measurement.
Remote command:
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:SRANge:STOP
on page 505
Use as X Scale - Power Analysis
This parameter is only available for Configure measurement settings > "Frequency"
and Use Separate Frequency- Power Analysis > "Active".
Activates the use of the separate frequency min and max values for the scaling of the
x-axis. Thus, the trace for this sensor is visible in the diagram , especially for frequency
ranges that differ substantially from the generator settings.
If more than one sensor is active, which use separate frequencies, the option is only
available for one sensor. To indicate the traces of the other sensors, use function "Map
to X Scale".
Remote command:
n.a.
Map to X Scale - Power Analysis
This parameter is only available for Configure measurement settings > "Frequency"
and Use Separate Frequency- Power Analysis > "Active".
Using power sensors