R&S SMA100B - Page 510

Remote control commands
R&S
®
SMA100B
510User Manual 1178.3834.02 ─ 09
Example:
SENS1:SWE:TIME:SENS:SFR 2GHz
The measurement is performed at 2 GHz
Manual operation: See "Use Separate Frequency- Power Analysis" on page 261
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:SFRequency:STATe <State>
Activates the use of a different frequency for the power measurement.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SENS1:SWE:TIME:SENS:SFR:STAT ON
Activates the use of a separate frequency than the generator fre-
quency for power analysis
Manual operation: See "Use Separate Frequency- Power Analysis" on page 261
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:TRIGger:AUTO
<Auto>
Sets the trigger level, the hysteresis and the dropout time to default values.
Parameters:
<Auto> ONCE
*RST: ---
Example:
SENS1:SWE:TIME:SENS:TRIG:AUTO ONCE
The trigger level is automatically determined
Manual operation: See "Auto Set - Power Analysis" on page 274
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:TRIGger:DTIMe <DTime>
Determines the minimum time for which the signal must be below (above) the power
level defined by level and hysteresis before triggering can occur again.
Parameters:
<DTime> float
Range: 0 to 10
*RST: 200E-9
Example:
SENS1:SWE:TIME:SENS:TRIG:DTIM 10 us
The drop out time is 10 us
Manual operation: See "Drop out Time - Power Analysis" on page 273
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:TRIGger:HYSTeresis <Hysteresis>
Sets the hysteresis of the internal trigger threshold. Hysteresis is the magnitude (in dB)
the trigger signal level must drop below the trigger threshold (positive trigger slope)
before triggering can occur again.
Power sensor measurement subsystems