R&S SMA100B - Page 525

Remote control commands
R&S
®
SMA100B
525User Manual 1178.3834.02 ─ 09
Parameters:
<Mode> FREQuency | POWer | TIME
*RST: FREQuency
Example:
SENS:SWE:MODE FREQ
Selects frequency mode.
Manual operation: See "Mode - Power Analysis" on page 256
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:COPY
Generates a reference curve for "Power" measurement.
Example:
SENS:POW:SWE:POW:REF:DATA:COPY
Generates a reference curve in power mode.
Usage: Event
Manual operation: See "Save To Ref" on page 254
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:POINts?
Queries the number of points from the reference curve in "Power" measurement.
Return values:
<Points> integer
Range: 10 to 1000
Example:
SENS:POW:SWE:POW:REF:DATA:POIN?
Queries the number of points from the reference curve in power
mode.
Usage: Query only
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:XVALues <XValues>
Sets or queries the x values of the two reference points, i.e. "Power X (Point A)" and
"Power X (Point B)" in "Power" measurement.
Parameters:
<XValues> string
Example:
SENSe:POW:SWE:POW:REF:DATA:XVAL -15DBM,20DBM
Sets the x value of reference "Point A" to -15 dBm, and the
value of "Point B" to 20 dBm.
Manual operation: See "Pow (X)" on page 253
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:YVALues <YValues>
Sets or queries the y values of the two reference points, i.e. "Power Y (Point A)" and
"Power Y (Point B)" in "Power" measurement.
Power sensor measurement subsystems