R&S SMA100B - Page 622

Remote control commands
R&S
®
SMA100B
622User Manual 1178.3834.02 ─ 09
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Depth" on page 164
[:SOURce<hw>][:ILS]:MBEacon:COMid:DOT <Dot>
Sets the length of a Morse code dot.
Parameters:
<Dot> float
Range: 0.05 to 1
Increment: 1E-4
*RST: 0.1
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Dot Length" on page 165
[:SOURce<hw>][:ILS]:MBEacon:COMid:FREQuency <Frequency>
Sets the frequency of the COM/ID signal.
Parameters:
<Frequency> float
Range: 0.1 to 20E3
Increment: 0.01
*RST: 1020
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Frequency" on page 164
[:SOURce<hw>][:ILS]:MBEacon:COMid:LETTer <Letter>
Sets the length of a Morse code letter space.
Parameters:
<Letter> float
Range: 0.05 to 1
Increment: 1E-4
*RST: 0.3
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Letter Space" on page 165
SOURce subsystem