R&S SMA100B - Page 723

Remote control commands
R&S
®
SMA100B
723User Manual 1178.3834.02 ─ 09
:SYSTem:COMMunicate:GPIB:RESource?
Queries the visa resource string for remote control via the GPIB interface.
To change the GPIB address, use the command :SYSTem:COMMunicate:GPIB[:
SELF]:ADDRess.
Return values:
<Resource> string
Example: See Example "Finding out the used VISA resource strings"
on page 713.
Usage: Query only
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
Sets the GPIB address.
Parameters:
<Address> integer
Range: 0 to 30
*RST: n.a. (factory preset: 28)
Example: See Example "Finding out the used VISA resource strings"
on page 713.
Manual operation: See "GPIB Channel Address" on page 402
:SYSTem:COMMunicate:HISLip:RESource?
Queries the VISA resource string. This string is used for remote control of the instru-
ment with HiSLIP protocol.
Return values:
<Resource> string
Example: See Example "Finding out the used VISA resource strings"
on page 713.
Usage: Query only
Manual operation: See "HISLIP" on page 401
:SYSTem:COMMunicate:NETWork:IPADdress <IpAddress>
Sets the IP address.
Parameters:
<IpAddress> string
Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example "Retrieving information on network-related set-
tings" on page 713.
SYSTem subsystem