R&S SMA100B - Page 499

Remote control commands
R&S
®
SMA100B
499User Manual 1178.3834.02 ─ 09
Manual operation: See "State - Gate" on page 276
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STARt <Start>
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STOP <Stop>
Sets the start time of the selected gate. Insert value and unit.
Parameters:
<Stop> float
Increment: 1E-12
*RST: Start/Stop: 5/15 (Gate1), 25/35 (Gate2)
Example:
CALC:SWE:TIME:GATE2:STAR 20us
Sets a start time of 20 us for gate 2.
CALC:SWE:TIME:GATE2:STOP 30us
Sets a stop time of 30us for gate 2.
Options: Option R&S SMAB-K28
Manual operation: See "Start / Stop - Gate" on page 276
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STATe <State>
Activates the gate settings for the selected trace. The measurement is started with
command SENS:POW:INIT. Both gates are active at one time.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
CALC:SWE:TIME:GATE:STAT ON
Enables time gated measurement.
Options: Option R&S SMAB-K28
Manual operation: See "State - Gate" on page 276
:CALCulate[:POWer]:SWEep:TIME:MATH<ch>:STATe <State>
Activates the trace mathematics mode for "Time" measurement. This feature enables
you to calculate the difference between the measurement values of two traces. For fur-
ther calculation, a math result can also be assigned to a trace.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
CALC:POW:SWE:TIME:MATH1:STATe
Switches on math mode.
Options: R&S SMAB-K28
Manual operation: See "Mathematics - Trace Power Analysis" on page 251
Power sensor measurement subsystems