R&S SMA100B - Page 175

List and sweep mode
R&S
®
SMA100B
175User Manual 1178.3834.02 ─ 09
Single / Extern Single mode (Sweep/List)
Figure 7-4: Single / Extern Single mode (sweep / list )
In single mode, you can specify, that the signal returns to the start value when a sweep
cycle has been completed.
See "The Retrace function" on page 180 for details.
●
The instrument generates a single sweep cycle.
●
Trigger mode "Manual". A trigger event initiates one sweep from the start value to
the end value.
●
"State = On" sets the signal to the start value: the sweep start frequency, the
sweep start power or the frequency-power value pair of the selected index in the
list.
●
Starts signal generation with a trigger event.
●
Switches automatically to the next step when the Dwell time has elapsed.
●
Stops signal generation at the set end value and waits for the subsequent trigger
event.
●
Trigger sources:
– The "Execute Single Sweep" function.
– The corresponding remote control command.
– An externally applied trigger signal.
●
"State = Off" stops the signal generation in sweep or list mode.
Signal generation and triggering in the sweep and list modes