R&S SMA100B - Page 240

Improving level performance
R&S
®
SMA100B
240User Manual 1178.3834.02 ─ 09
The "Overview" tab shows the list of detected sensors, and provides a separate tab
per sensor.
A sensor tab contains all parameters for configuring the sensor settings, like aver-
age or peak display, reference source, filter and level offset.
The remote commands required to define these settings are described in Chap-
ter 14.15, "SENSe, READ, INITiate and SLISt subsystems", on page 546, including
the triggering of the measurement and the retrieval of measurement results.
See also Chapter 8.5, "How to calibrate the power level with an R&S NRP power
sensor", on page 290.
Settings
Sensor type and serial number................................................................................... 241
Level (Peak) / Level (Average)....................................................................................241
Sensor Mapping..........................................................................................................241
Sensor settings........................................................................................................... 241
└ State..............................................................................................................241
└ Zero...............................................................................................................241
Using power sensors