R&S SMA100B - Page 271

Improving level performance
R&S
®
SMA100B
271User Manual 1178.3834.02 ─ 09
:TRACe<ch>[:POWer]:SWEep:MEASurement:TRANsition:NEGative:
OVERshoot? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:TRANsition:NEGative:
OVERshoot:DISPlay:ANNotation[:STATe] on page 541
Signal Power - Pulse Data Analysis
Selects the power parameters of the pulse signal to be indicated below the measure-
ment diagram.
Minimal / Peak / Average Power ← Signal Power - Pulse Data Analysis
Display the minimum, the maximum and the average power of the pulse signal in dBm.
Remote command:
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:MINimum? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:MINimum:DISPlay:
ANNotation[:STATe] on page 541
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:MAXimum? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:MAXimum:DISPlay:
ANNotation[:STATe] on page 541
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:AVERage? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:AVERage:DISPlay:
ANNotation[:STATe] on page 541
Pulse Power - Pulse Data Analysis
Selects which pulse power parameters are indicated in the diagram (pulse data view
only).
Top / Base Power ← Pulse Power - Pulse Data Analysis
Indicate the pulse top and base level of the analyzed signal in dBm.
Remote command:
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:BASE? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:BASE:DISPlay:
ANNotation[:STATe] on page 541
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:TOP? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:PULSe:TOP:DISPlay:
ANNotation[:STATe] on page 541
Distal / Mesial / Proximal Power ← Pulse Power - Pulse Data Analysis
Display the absolute power values of the medial, low and high reference level in dBm.
Remote command:
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:LREFerence? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:LREFerence:DISPlay:
ANNotation[:STATe] on page 541
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:HREFerence? on page 540
:TRACe<ch>[:POWer]:SWEep:MEASurement:POWer:HREFerence:DISPlay:
ANNotation[:STATe] on page 541
Using power sensors