R&S SMA100B - Page 295

Reference oscillator
R&S
®
SMA100B
295User Manual 1178.3834.02 ─ 09
In the "Reference Frequency" tab, you can select the reference frequency signal
source and the frequency and synchronization bandwidth mode of an external ref-
erence signal.
2. Observe the information on the home screen, "Frequency" tile.
Observe the information on the home screen, "Measurement Setup" tile.
The "Frequency" tile indicates the current reference oscillator configuration, incl.
the reference oscillator source, external reference frequency (rounded value) and
output connector. A warning symbol in the "Frequency" tile indicates a missing
external source.
The remote commands required to define these settings are described in Chap-
ter 14.16.12, "SOURce:ROSCillator subsystem", on page 691.
Settings:
Set to Default.............................................................................................................. 296
Source.........................................................................................................................296
Show Connector..........................................................................................................296
Reference frequency settings