Network operation and remote control
R&S
®
SMA100B
435User Manual 1178.3834.02 ─ 09
How to record SCPI lists manually
1. To retrace your settings, open the context-sensitive menu and select "Mark all
Parameters Changed from Preset".
This function identifies and highlights all settings you have changed, both in the
block diagram, and in the dialogs.
2. For selectively recording your steps:
a) Set the parameter.
b) Open the context-sensitive menu.
c) Select "Add SCPI Command to Recording List"
Tip: You cannot see "Add SCPI ..." in the menu?
A possible reason is opening the menu outside of a dialog or input field, for
example in a block diagram. Open the context-sensitive menu within the corre-
sponding dialog or input field, and the feature is available.
d) Continue with the next setting, and repeat steps a to b whenever needed.
Each time you select "Add SCPI ...", the SCPI command is appended to a tempo-
rary list.
3. To check the progress of the recording, select "Context-Sensitive > Show SCPI
Recording List".
The "SCPI Recording List" dialog opens, displaying all recorded settings so far.
4. Proceed with How to check a SCPI list.
How to create a SCPI list with the current instrument settings in one step
You can also generate a SCPI list from a manually created instrument state at any
time, in only one step.
Automating tasks with remote command scripts
To Next Page
Loading...
