R&S SMA100B - Page 48

Getting started
R&S
®
SMA100B
48User Manual 1178.3834.02 ─ 09
The blue colored "RF On" icon indicates that the RF output is activated.
The R&S SMA100B provides the 6 GHz signal at the RF A connector at the front
panel.
Figure 3-7: Generating an unmodulated signal
Alternative ways to access the instrument functions
To fulfill the same task, you can also use the front panel keys or the setting parameters
provided in the frequency and level dialogs.
Try out the settings dialogs
1. In the "Frequency" tile, select "Frequency...".
a) In the "RF Frequency" tab, tap the "Frequency" field.
b) Set the frequency via the on-screen keypad.
2. Access the "RF Level" dialog via the "Level" tile.
a) In the "RF Level" tab, select "Amplitude".
b) Set the amplitude (level) via the on-screen keypad.
3. Select "RF State > On" to activate the RF signal generation.
See Chapter 4, "RF signal configuration", on page 64.
Try out the front panel keys
► Use the [Freq], [Level], and [RF on/off] key on the front panel.
Trying out the instrument