R&S SMA100B - Page 495

Remote control commands
R&S
®
SMA100B
495User Manual 1178.3834.02 ─ 09
Example:
CALC:POW:SWE:FREQ:MATH2:STATe
Switches on math mode in trace 2.
Options: R&S SMAB-K28
Manual operation: See "Mathematics - Trace Power Analysis" on page 251
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:SUBTract <Subtract>
Subtracts the operands 1 and 2 and assigns the result to the selected trace in "Fre-
quency" measurement mode.
Parameters:
<Subtract> T1T1 | T1T2 | T1T3 | T1T4 | T1REf | T2T1 | T2T2 | T2T3 | T2T4 |
T2REf | T3T1 | T3T2 | T3T3 | T3T4 | T3REf | T4T1 | T4T2 |
T4T3 | T4T4 | T4REf
Example:
CALC:POW:SWE:FREQ:MATH4:SUBT T2REF
Subtracts the Reference and Trace 2, and assigns the result to
Trace 4. The resulting curve is shown in the diagram.
Options: R&S SMAB-K28
Manual operation: See "Mathematics - Trace Power Analysis" on page 251
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:XVAL <XVal>
Sets the x-axis values for calculating the reference curve in frequency measurement
mode.
To determine two points ("Point A"/"Point B"), set suffix 1 and 2 in keyword MATH<ch>.
Parameters:
<XVal> float
Range: 0 to 1E12
Increment: 1
*RST: 1E12
Example:
CALCulate:POWer:SWEep:FREQuency:MATH1:XVAL 8000
CALCulate:POWer:SWEep:FREQuency:MATH2:XVAL
1000000000
Sets the frequency points to calculate the reference curve.
Options: R&S SMAB-K28
Manual operation: See "Freq (X)" on page 253
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:YVAL <YVal>
Sets the y-axis values for calculating the reference curve in frequency measurement
mode.
To determine two points ("Point A"/"Point B"), set suffix 1 and 2 in keyword MATH<ch>.
Power sensor measurement subsystems