R&S SMA100B - Page 52

To Next Page

To Previous Page

Getting started

R&S

SMA100B

52User Manual 1178.3834.02 ─ 09

4. In the "Save/Recall" dialog, select "Operation Mode > Recall".

Navigate to the directory the file is saved in and select the MyTestSignal file.

5. Tap the "Recall" button.

All instrument settings are restored and the display resembles Chapter 3.3.2, "Gen-

erating an RF frequency sweep signal", on page 49, which shows the instrument

display right before the settings were saved.

How to display all parameters with values different to their preset values

When you load a file to your instrument, you do not have enough information on the

changed settings. In such case, it is useful to visualize all parameters that have been

changed from their default state.

Try out the following:

●

Touch and hold a spot in the tile diagram for at least 1 second to access the con-

text-sensitive menu.

●

Select "Mark All Parameters Changed from Preset".

Trying out the instrument

Other manuals for R&S SMA100B