Page Keeper Type M28 (D3DQ-17)
D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1 2-74 SM
8. Route the harnesses [B].
9. Reattach the inner cover ( x5), and then reattach the SPDF top cover ( x1).
Make sure the SPDF top cover is set correctly so that the two tabs fit into the holes.
10. Attach the clamp while the top cover is open, and then attach the ground wire while putting
it on the guide (marked by the blue arrow). (Screw: M3x6)
Connecting the harnesses
1. Connect the harness to the connector of the double-feed sensor (emitter) [A] and SPDF
relay board [B] (CN3), and then route it.
Connect with attention to the connector colors.
- Double-feed sensor: White connector
- SPDF relay board: Black connector
To Next Page
