Page Keeper Type M28 (D3DQ-17)
SM 2-75 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
2. Connect the harnesses [A] from the SPDF top cover to the connectors of the SPDF relay
board [B] (CN5, CN6).
3. Reattach the covers and original feed unit.
When reattaching the SPDF inner cover, make sure that the shaft [A] fits into the groove
(this is the shaft of the lock lever for the friction pad on the back side of the cover). If the
shaft does not fit, the SPDF top cover will not be closed.
When reattaching the SPDF inner cover [A], move it under the coupling shaft (marked by
the dashed circle) of the original feed unit, and then you can install the SPDF inner cover
correctly.
To Next Page
