Shimadzu GC-2010 Plus - Setting the Output Signals; Detector Signal Output

13 Detector
13.5
13.
170
GC-2010 Plus
13.5Setting the Output Signals
13.5.1 Detector signal output
Fig. 13.5.1 Location of connector
Set the detector signal (digital and analog signals) output from the gas chromatograph.
There are four signal output channels. Ch3 and Ch4 are available optionally.
Both digital and analog signals can be output from one channel. Even if two or more
channels are set, signals can be output from each channel at the same time.
Detector signals are transferred through an RS-232C cable (for digital signals, only when a
personal computer are used) and the chromatopac signal cable (for analog signals).
RS-232C
ch1
ch2